To Attach The Saw Blade Guard - Husqvarna 545RXT AutoTune Manual Del Usuario

2. Release the locking hooks with the spark plug
wrench to remove the guard extension.
To attach the grass blade and the grass blade
guard/combination guard
1. Put the blade guard/combination guard (A) onto the
shaft and tighten the bolt to attach it.
2. Make sure that the guard extension is removed.
3. Turn the output shaft to align one of the holes in the
drive disc (B) with the related hole in the gear
housing.
4. Put the locking pin (C) in the hole to lock the shaft.
5. Put the grass blade (D), the support cup (E) and the
support flange (F) on the output shaft.
D
C
A
12
A
G
E
F
B
6. Make sure that the drive disc and support flange
engages correctly in the centre hole of the grass
blade.
7. Attach the nut (G).
8. Tighten the nut with the socket wrench. Hold the
shaft of the socket wrench near the blade guard.
Tighten in the opposite direction to how the cutting
attachment rotates. Tighten it to a torque of 35-50
Nm.
To attach the saw blade guard on 545FX AT
and 545FXT AT
• Attach the saw blade guard (A) with the 4 screws (L).

To attach the saw blade guard

1. Attach the holder (A) and bracket (B) with 2 bolts (C)
on the gear housing (D).
2. Attach the saw blade guard (E) with 4 bolts (F) in the
holder (A).
B
C
D
L
A
A
F
E
171 - 008 - 08.06.2020