Important Notes - Hartmann Veroval Instrucciones De Uso

English
EN

2. Important notes

Signs and symbols
Follow instructions for use
Please note
Dispose of in an environmentally responsible way
Dispose of in an environmentally responsible way
Symbol regarding electrical and electronic equipment labelling
Direct current
Declaration of conformity
LOT Batch number
REF Reference number
21
Cardboard recycling code
PAP
SN Serial number
Important information about use
The scale must not be used by people with active medical implants (e.g. a pacemaker). The scale may negatively affect the function of these devices.
Not suitable for people with electrically conducting implants (e.g. artifi cial hip joints).
Do not use during pregnancy.
Do not stand on the outer edge of only one side of the scale (risk of tipping).
Keep packaging material out of the reach of children (risk of suffocation).
The scale is only intended for personal use at home, not for medical or commercial use.
Please note that for technical reasons there are tolerances in the measurements because this scale is not calibrated for professional medical use.
Place the scale on a level, solid surface and not on carpet or on a damp or wet fl oor. A solid fl oor covering is essential for correct measurement.
Do not stand on the scale with wet feet or socks (risk of slipping).
The minimum weight that can be measured is 5 kg.
The maximum capacity is 180 kg. A load greater than this may damage the scale.
Power supply (batteries)
Observe the polarity labels plus (+) and minus (-).
Only use high-quality batteries (see specifi cation in Chapter 13 'Technical data'). If you use low-quality batteries, we can no longer guarantee the spec-
ifi ed number of measurements.
Never mix old and new batteries or batteries from different manufacturers.
Remove empty batteries immediately.
Replace batteries if the battery symbol
teries for the platform or control unit are low; see Chapter 8 'Error messages'.
Always replace all the batteries at the same time.
If you do not intend to use the scale for a longer period, you should remove the batteries to prevent possible leakage from the batteries.
remains illuminated. The error messages Lo-1 (platform) or Lo-2 (control unit) indicate whether the bat-
26