Assembly - STOK TOURIST Manual Del Operador

UNPACKING
This product requires assembly.
 Carefully lift grill from the carton and place it on a level
work surface.
WARNING:
Do not use this product if any parts on the Loose Parts List
are already assembled to your product when you unpack
it. Parts on this list are not assembled to the product by
the manufacturer and require customer installation. Use
of a product that may have been improperly assembled
could result in serious personal injury.
 Inspect the grill carefully to make sure no breakage or
damage occurred during shipping.
 Do not discard the packing material until you have
carefully inspected the grill, identified all loose parts, and
satisfactorily operated the grill.
NOTE: Some loose parts are located inside the grill
assembly beneath the hood.
 If any parts are damaged or missing, please call
1-800-847-5993 for assistance.
WARNING:
If any parts are damaged or missing, do not operate
this grill until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
CAUTION:
Some parts may contain sharp edges that may cause
personal injury. Wear protective gloves if necessary.
WARNING:
Always place the grill/camp stove on a flat, level non-
flammable surface. Failure to do so may cause the grill
to tip over and could cause serious personal injury.

ASSEMBLY

STEP 1: ATTACHING THE HANDLE ASSEMBLY
See Figure 4.
 Remove the insulator pads, washers, and wing nuts from
the handle assembly.
 Insert the screws in the handle assembly through insulator
pads and corresponding holes in the hood.
NOTE: Ensure insulator pads remain between the handle
and the hood.
 Install wing nuts and washers and tighten.
NOTE: Do not overtighten wing nuts to avoid cracking
the porcelain surface of the hood.
SCREW
INSULATOR
PAD
Fig. 4
8 — English
HANDLE
ASSEMBLY
HEAT
SHIELD
WING NUT
WASHER