STOK TOURIST Manual Del Operador página 9

STEP 2: RAISING THE TOURIST
BURNER/BASE ASSEMBLY TO THE
STANDING POSITION
See Figures 5 - 6.
 Place burner/base assembly top down on a level surface.
 The rear and side legs are spring loaded. While holding
spring loaded leg firmly, release the leg retaining clip on
bottom of the base as shown.
 Slowly allow the spring loaded legs to raise to their fully
upright position.
 Place burner/base assembly upright on a flat, level non-
combustible surface so it rests on its legs.
RETAINING CLIP
Fig. 5
REAR LEG
Fig. 6
ASSEMBLY
GRILL
™
REAR LEG
9 — English
STEP 3: INSTALLING THE FIREBOX AND
HEAT TENT
See Figures 7 - 8.
 Hold the firebox over the burner/base assembly with the
notched cut out to the left and the drain hole to the rear.
NOTE: The control knob is on the front of the firebox.
Ensure that the cut out is not over the control knob or
piezo ignitor.
 Align the notches on the bottom of the firebox with the pot
stand on the burner/base assembly and set the firebox
into place.
 Attach the three retaining clips on the burner/base
assembly over the edge of the firebox as shown.
FIREBOX
NOTCHED
CUT OUT
NOTCH
BURNER/BASE
ASSEMBLY
Fig. 7
DRAIN HOLE
RETAINING
CONTROL
KNOB
TOP VIEW
LOCATION OF
RETAINING CLIPS
CLIP