Purpose Of Use; Work Area Safety - Beta 1760/RSE Manual De Uso E Instrucciones

OPERATION MANUAL AND INSTRUCTIONS ISTRUZIONI PER L'USO
OPERATION MANUAL AND INSTRUCTIONS FOR INSTANT SIGNAL DETECTOR ITEM 1760/RSE MANUFACTURED BY:
BETA UTENSILI S.P.A.
Via A. Volta 18,
20845, Sovico (MB)
ITALY
Original documentation drawn up in ITALIAN.
CAUTION
Store the safety instructions with care and hand them over to the users.

PURPOSE OF USE

- The signal detector allows the power supply of electromechanical/electronic parts to be tested:
• common rail electro-injectors, petrol/LPG electro-injectors, piezoelectric injectors
• flow-regulating solenoid valves, EGR solenoid valves, variable-geometry solenoid valves
• high-voltage coils, spark plugs
- The signal detector must not be used for the following operations:
• use outside the technical specifications contained in the TECHNICAL DATA table
• use in humid or wet environments, or in bad weather
• use for any applications other than the stated ones

WORK AREA SAFETY

Do not operate the signal detector in environments containing potentially explosive atmospheres or inflammable
materials, because sparks may be generated, which can ignite the dust or fumes.
Keep children and bystanders away from your workplace while operating the energy efficiency tester. Distractions from
other people can cause you to lose control over the signal detector during use.
While operating the signal detector, pay special attention to the moving parts of the engine.
Do not drop any metal tools on the motor vehicle battery: it may short-circuit.
Use the signal detector in a dry area, avoiding humidity.
SIGNAL DETECTOR SAFETY
- Before use, check that the signal detector has not been damaged, and that there are no uncovered cables or worn parts.
- Do not use the signal detector when damaged, to avoid the risk of electric shocks; do not try to open or modify it.
- Periodically check the signal detector, the power supply cable and the clamps.
- Do not cover the signal detector when using it. Allow adequate space for ventilation.
- Do not use the signal detector in humid or wet environments; do not expose it to rain. Wet and contaminated environments
increase the risk of electric shocks.
PERSONNEL SAFETY
- Stay alert; watch what you are doing. Do not use the signal detector while tired or under the influence of drugs, alcohol, or
medications.
- Always use the following personal protective equipment:
• safety shoes;
• eye protection;
• protective gloves against physical agents.
6
IMPORTANT! READ THIS MANUAL THOROUGHLY BEFORE USING THE
PNEUMATIC TOOL. FAILURE TO COMPLY WITH THE SAFETY STANDARDS AND
OPERATING INSTRUCTIONS MAY RESULT IN SERIOUS INJURY.
EN I