Technical Data - Beta 1760/RSE Manual De Uso E Instrucciones

OPERATION MANUAL AND INSTRUCTIONS ISTRUZIONI PER L'USO
- Carry out all operations in well-aired, dry rooms.
- Check that the cables of the signal detector are kept away from fans, moving parts and the fuel pipe.
- Do not wear loose clothing, jewellery or metal objects when working on the motor vehicle.
- Clean the battery terminals, preventing corrosive agents from coming into contact with the skin or eyes.
SIGNAL DETECTOR USE AND CARE
- Do not use the signal detector if the case, the clamps, the cables or the power supply cable have been damaged, if it gives off
unusual smells or too much heat.
- Do not modify the signal detector. This can reduce the effectiveness of safety measures and increase operator risk.
- Have the signal detector repaired only through a trained repair person and only using original replacement parts.
- Do not use the signal detector with any voltages other than those stated in the TECHNICAL DATA table.
PERSONAL PROTECTIVE EQUIPMENT TO WEAR WHILE OPERATING SIGNAL DETECTOR
Failure to observe the following warnings may result in physical injury and/or disease.
ALWAYS WEAR SAFETY SHOES
ALWAYS WEAR EYE PROTECTION
ALWAYS WEAR PROTECTIVE GLOVES AGAINST PHYSICAL AGENTS WHILE
OPERATING TOOL
Additional personal protective equipment to wear according to the values found in the environmental
hygiene/risk analysis survey if the values exceed the limits under current regulations.

TECHNICAL DATA

OPERATING VOLTAGE
ABSORBED POWER
STORAGE TEMPERATURE
DIMENSIONS
CLAMP CABLE LENGTH
PROBE CABLE LENGTH
WEIGHT
12VDC (motor vehicle battery)
1 watt
5 °C ÷ 50 °C
160x80x32 mm
1.4 m
0.95 m
0.263 kg
EN I
7