Menu Adjustments - IMG STAGELINE LITEBOX-10 Manual De Instrucciones

7 Operation
Switch on the unit
DMX operation:
Once the unit receives a signal from a DMX con-
troller, it is switched to DMX operation (indication of
the start address adjusted, e. g.
menu, adjust the DMX start address, the number of
DMX channels and, if required, the brightness of
the LEDs. For the functions and DMX values refer
to chapter 9.1.
Operation without DMX controller:
– If the unit is set to "Master", it is switched to the
show mode last adjusted (indication
... , or
– If the unit is set to "Slave" and does not receive a
signal from a master unit, it is switched to stand-
by (indication
from the master unit, it is switched to the slave
mode (indication
show mode as the master unit.
Via the menu, adjust the unit to "Master" (individual
unit or master in the master/slave mode) or "Slave"
Main menu
chapter 5 or 6.
). Via the
).
). Once it receives a signal
), i. e. it runs in the same
Œ
DMX start address

Number of DMX channels
Ž
Master/slave

Show mode

Manual colour adjustment
‘
Test program
’
Operating hours
(slave in the master/slave mode) and select the
show mode for the master unit. If required, adjust
the brightness of the LEDs.

7.1 Menu adjustments

The menu is operated via the four buttons (2):
1) Call the menu with the button MENU.
2) Select the desired menu item with the button UP
(or MENU) or DOWN and call it with the button
ENTER.
3) Select the desired adjustment with the button
UP or DOWN and confirm it with the button
,
ENTER.
For detailed information about the individual menu
items please refer to figs. 1 to 7.
The menu is automatically exited 15 s after the last
button has been pressed and the unit is switched
back to its present operating mode. (Exception:
must manually be stopped.) To exit the menu
immediately, keep the button MENU pressed until
the unit is switched back to its operating mode.
DMX start address
Œ
Number of
DMX channels

Master/slave
Ž
Note on the master/slave mode: When receiving a control
signal, a unit set to "master" in the menu is automatically
switched to the slave mode, however, its menu adjustment
remains "master". As this may lead to malfunctions (e. g. when
changing the show mode), units operated as slaves should
always be set to "slave" in the menu.
4 channels
8 channels
master
slave
GB
11