Setting Up Your Meter - BIONIME GM300 Manual Del Usuario

Setting Up Your Meter

Entering Setting Mode
You can enter Setting Mode by below two ways.
1. Reload batteries : After removing the battery, please press "
follow the steps of page 20~21 to load batteries.
2. With batteries : Press " " button for 5 seconds till hearing a sound of " beep ". The display screen will show setting
data.
PRECAUTION
When you keep pressing " " button for 2 seconds, the display on screen will turn off. Please don't care it. Keep
pressing the " " button till entering Setting Mode.
22
" button for several times until no signal on screen, then
Setting the Time, Date and Unit
1. Year setting
With the year format blinking, press the " " or "
" " button to confirm the year adjustment and move to month setting.
2. Month setting
With the month blinking, press the " " or " " button until the current month appears. Then press
the " " button to confirm it and move to day setting.
3. Day setting
With the day blinking, press the " " or " " button until the current day appears. Then press the "
button to confirm it and move to time format setting.
Setting Up Your Meter
" button on the side to adjust it. Then press the
"
23