Basic Saw Operations; Auxiliary Fence; Switch Activation - Bosch 5412L Instrucciones De Funcionamiento Y Seguridad

Basic Saw Operations

Auxiliary Fence

Certain types of molding need a fence face extension
because of the size and position of the workpiece.
Holes are provided in the fence to attach an auxiliary
fence. The auxiliary fence is used with the saw in the
0° bevel position only.
1. Place a piece of wood against the miter saw fence
(Figure 22). (Wood can have a maxi-
mum height of 4-1/2". Check that auxiliary
fence assembly does not interfere with head
assembly.
For splinter-free cuts of molding, attach a one piece
wood auxiliary fence and then cut openings with
miter saw.
2. Mark the locations of the support holes on the
wood from the back side of the fence.
3. Drill and countersink the holes on the front of the
support board.
4. Attach (each) auxiliary fence using two (2)
3/16" flat head machine screws. With 3/4" auxiliary
fence use 1-1/2" long screws. Secure behind
metal fence with washer and machine nuts.
Alternate: With 3/4" auxiliary fence, use 1/4" round
head screws wood screws (3/4" long). Drill four (4)
smaller (then 1/4 pilot holes through auxiliary
"
fence and run screws through rear of metal fence.
5. Make a full depth cut to create the blade slot.
Check for interference between the auxiliary fence
For safety, the switch lever is designed to prevent
accidental starts. To operate safety switch, press the
switch "Lock-OFF" button with either thumb to disen-
gage the lock, then pull the power switch lever and
release the switch "Lock-OFF" release button
(Figure 23). When the power switch lever is released,
the switch "Lock-OFF" button will engage the safety
switch automatically, and the lever will no longer
operate until either "Lock-Off" button is pressed
again.
NOTE: Switch lever can accommodate a padlock
with a long shackle of up to 1/4" in diameter (not
provided with miter saw to prevent unauthorized use.
and the lower blade guard. Make adjustments as
necessary.
WARNING
!
Auxiliary
Fence

Switch Activation

21.
Check for interference from any
components.
Blade Slot
Flat Head
Machine Screws
Figure 22. Auxiliary Fence
Switch
"Lock-Off"
Release Button
Figure 23. Switch Activation
Power
Switch Lever