Transporting, Placement And Mounting; Mounting Applications - Bosch 5412L Instrucciones De Funcionamiento Y Seguridad

Transporting, Placement and Mounting

To avoid injury always observe the
! WARNING
following:
Unplug electric cord. Before transporting the saw,
G
rotate head and lock assembly to 60° right miter,
lock into detent, slide head assembly to the middle
of it's rail, tighten the slide rail lock knob and lock
the head assembly in the lowered position.
Lifting Saw
To avoid back injury, hold the tool close to your
G
body when lifting. Bend your knees so you can lift
with your legs, not your back.
Lift by using the cast-in carry handles at each
G
side of the bottom of the base.
Alternate lifting method: When picking tool up
G
from ground, use rear carrying handle and front
carrying handle (above guard).
Never carry the tool by the slide rails, this
G
may cause blade damage.
Workbench
Mount the saw using either the four bolt holes (5/16")
or the four nail holes to the workbench (Figure 14).
Check for clearance to the left and right of the saw.
Rear Carrying
Front Carrying
Handle
Handle
Bolt Hole
Figure 14. Workbench Mounting

Mounting Applications

Nail Hole
Never lift tool by holding switch handle. This
G
may cause serious damage.
Never carry the miter saw by the power cord or the
G
operational handle. Attempting to lift or carry the
tool by the power cord will damage the insulation
and the wire connections resulting in electric shock
or fire.
Observe the position of the saw. People standing
G
behind it could be injured by thrown debris.
Place the saw on a firm, level surface where there
G
is plenty of room for handling and properly sup-
porting the workpiece.
Bolt, nail or clamp the saw to its support.
G
Be careful not to over-drive nail
! CAUTION
or over-torque the bolt. This could
crack foot or damage base.
1. Each of the four mounting holes should be bolted
securely using 5/16" bolts, lock washers, and hex
nuts (not included).
2. Locate and mark where the saw is to be mounted.
3. Drill four (4) 5/16" diameter holes through work-
bench.
4. Place the miter saw on the workbench aligning
holes in base with holes drilled in workbench.
Install bolts, lock washers and hex nuts. As an
alternative, you can mount the saw using drywall
screws in the four nail holes.
Supporting surface where saw is to be mounted
should be examined carefully after mounting to
ensure that no movement can occur during use. If
any tipping or walking is noted, secure the work-
bench or stand before operating the slide com-
pound miter saw.
17.