Engine Maintenance; Service &Maintenance; Maintenance Schedule - Craftsman CMXGBAM1054541 Manual De Instrucciones

Ocultar thumbs Ver también para CMXGBAM1054541:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Before performing any type of maintenance/service, disengage all controls
and stop the engine. Wait until all moving parts have come to a complete
stop. Disconnect spark plug wire and ground it against the engine to
prevent unintended starting.
Interval
Each Use and every 5 hours
1.
2.
3.
1st 5 hours
1.
Annually or 25 hours
1.
2.
3.
4.
5.
Annually or 50 hours
1.
Annually or 100 hours
1.
Before Storage
1.

Engine Maintenance

Checking Engine Oil
Before lubricating, repairing, or inspecting, disengage all controls and stop
engine. Wait until all moving parts have come to a complete stop.
NOTE: Check the oil level before each use to be sure correct oil level is maintained.
NOTE: 208cc and 243cc engines use 600 ml (approx. 20 oz.).
NOTE: 277cc, 357 and 420cc engines use 1100 ml (approx. 37.2 oz).
When adding oil to the engine, refer to viscosity chart below. Do not over-fill. Use
a 4-stroke, or an equivalent high detergent, premium quality motor oil certified
to meet or exceed U.S. automobile manufacturer's requirements for service
classification SG, SF. Motor oils classified SG, SF will show this designation on the
container.
1.
Remove the oil filler cap/dipstick and wipe the dipstick clean.
2.
Insert the cap/dipstick into the oil filler neck, but do NOT screw it in.
3.
Remove the oil filler cap/dipstick. If level is low, slowly add oil until oil level
registers between high (H) and low (L). See Figure 52 or Figure 53.
4.
Replace and tighten cap/dipstick firmly before starting engine.
SERVICE AND MAINTENANCE

MAINTENANCE SCHEDULE

WARNING
Item
Engine oil level
Loose or missing hardware
Unit and engine.
Engine oil
Spark plug
Control linkages and pivots
Wheels
Gear shaft and Auger shaft
4-Way Chute Control
Engine oil
Spark plug
Fuel system
WARNING
Follow the maintenance schedule given below. This chart describes service
guidelines only. Use the Service Log column to keep track of completed
maintenance tasks. To locate the nearest Sears Service Center or to schedule service,
call the following toll free number:1-888-331-4569.
Service
1.
Check
2.
Tighten or replace
3.
Clean
1.
Change
1.
Check
2.
Lube with light oil
3.
Lube with multipurpose auto grease
4.
Lube with light oil
5.
Check for cable slackness
1.
Change
1.
Change
1.
Run engine until it stops from lack of fuel
Do not
fill above
High (H)
mark
28
Service Log
Figure 52
Do not
fill above
High (H)
mark
Figure 53

Hide quick links:

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Cmxgbam1054542Cmxgbam1054543Cmxgbam1054544Cmxgbam1054546

Tabla de contenido