Corghi Artiglio 500 Manual De Uso página 64

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 177
- Move the disk close to the rim by means of the button 12-1 and then lever 12-6.
IMPORTANT – with this operation, the two arms are moved together. Make sure therefore
that the lower arm is in idle position, fully down.
- Once the preset distance has been achieved ( a distance of 2-3 mm is advisable between
the rim edge and the bead-breaker disk), release the button and lever to stop hori-
zontal movement.
5 • Breaking the top bead (fig.13)
- Preload the bead breaker disc using control 2 (the tyre should be pressed down by
about 5 mm).
- Start disc penetration (control 1) and then start wheel rotation (pedal 3), while at the
same time lowering the bead breaker disc a little at a time (control 12-2).
- Perform at least one complete revolution to break the bead.
It is best to grease the rim bead during rotation.
- Return the bead-breaker unit upwards. With this command, bead-breaker disk pene-
tration is also reset
6 • Lower bead-breaker positioning (fig. 15)
- Raise the upper bead-breaker unit from idle position to operating position by means
of the lever 12-3
- NOTE – do not bring horizontally closer because when the upper arm comes closer so
does the lower arm.
- a distance of 2-3 mm is advisable between the rim edge and the bead-breaker disk
7 • Lower bead breaking (fig. 15)
- Pre-load the bead-breaker disk by means of the control 12-3 (pre-loading is recommen-
ded with tyre crushing by about 5 mm).
- Operate the disk penetration control 12-5 and then start wheel rotation (pedal control
3) while at the same time lowering the bead-breaker disk control 12-3
- Complete at least one full turn to achieve bead-breaking. It is best to grease the rim
bead during rotation.
- Return the bead-breaking unit down. With this control, bead-breaker disk penetration
is reset.
8 • Positioning the tool (fig. 16/17)
- Move the tool head into the working position (control 9-3).
- It may be useful to press the tyre down to make room for the tool.
- Release the tool by pulling block 23 towards you (A).
- For correct tool positioning, the insert 3 must be against the edge of the rim in the point
where the vertical wall starts (C).
- Press the block 2 to fix the tool position (D).
9 • Engaging the top bead (fig.18)
- Maintaining the pressure of the bead breaker disc on the tyre, create enough space to
allow the demount tool to be rocked.
- Using control 12-7, rock the demount tool.
- It is important to rotate the turntable slightly to facilitate engagement of the bead.
- For easier bead engagement, it might be very helpful to use the bead breaker disc on
the underside of the tyre 20a
64
Operator's manual Artiglio 500

Publicidad

Tabla de contenido
loading

Tabla de contenido