Operating Your Humidifier; Set Humidity - Honeywell HCM-300T Manual Del Usuario

HCM-300T_HCM-310T_OM.qxd

OPERATING YOUR HUMIDIFIER

Model # Output/Fan Speed Control
HCM-300T
Step 1
Set fan speed to desired
output:
High (
Fast Humidifying
Medium (
Everyday moisture control
Low (
Nighttime or
maintenance use
HCM-310T/
Step 1
HCM-315T
Press power to start unit
in high speed.
Step 2
Push ( + ) Up button or ( – )
Down button to select the
output level.
5/22/06 5:56 PM

Set Humidity

Step 1
Turn the humidistat knob
clockwise
highest setting (
)
Run on high for at least
1 hour or until room has
)
reached a comfortable
humidity level.
)
Step 1
Max: 55% Min: 35%
Use the (+) up or (–) down
button to set desired
humidity.
The unit will operate until the selected humidity is reached
or the unit is turned off. When desired humidity is reached,
the fan will shut off but LED will remain lit. The fan will turn
back on when the room humidity drops below the set
level.
NOTE: To go back to continuous run mode, turn your
unit off and on again.
NOTE: The UV bulb can be turned off and on using the
button.
Page 5
Step 2
Then slowly turn the
to the humidistat knob counter-
). clockwise
humidifier shuts off. The
desired humidity light will
illuminate.
Once set, the humidifier will
automatically cycle on and off
based on your setting.
until the
5