Utilitech 00761 Manual De Instrucciones página 12

EXISTING CONSTRUCTION (JOIST/ABOVE CEILING ACCESS APPLICATION) INSTALLATION
INSTRUCTIONS
5. Place two clips (BB) along the bottom edge of each
side of the housing (A). Place the housing (A) into the
opening, then mount the housing (A) to the joist.
Note: The clips (BB) will ensure the bottom edge of the
housing (A) is flush with the ceiling board.
Hardware Used
eclip ~
x4
6. Use long screws (AA) to screw the housing (A) directly
to the joist using keyhole mounting tab holes or holes on
the inside of the housing (A). Choose the side that best
works for the installation area. One side of the housing
(A) has a foam insert. Remove and discard this foam
insert when choosing that side.
Note: The bottom edge of the housing (A) must be flush
with the finished ceiling.
Hardware Used
• Long Screw
(f)
l)))) I II I))
l
II 1)) I
l
11) 1
llUJ;>
x 3
or 4
7. Secure the hanger bars (C):
a. Extend two hanger bars (C) to the joist.
b. Drive two long screws (AA) into joist at the top of
both keyholes.
c. Tighten two long screws (AA) securely.
Hardware Used
• Long Screw
(f)lllDll ))))) ) ) ) ) ) ) )
lll)l ))
)]>
x2
Proceed to Step 12 (Page 15).
12
foam-(~)
~UTILITECH"
J
Lowes .com
\:1 - · -