Preparation; Initial Installation Instructions - Utilitech 00761 Manual De Instrucciones

PREPARATION
Before beginning assembly of the product, make sure all parts are present. Compare parts with the
package contents list and hardware contents list. If any part is missing or damaged, do not attempt to
assemble the product.
Estimated Installation Time: 30 to 60 minutes
Tools Required for Assembly (not included): Flathead screwdriver, Phillips screwdriver, Hammer,
Nails, Duct tape, Saw, Measuring tape, Pencil, Ruler
INITIAL INSTALLATION INSTRUCTIONS
1. Remove the motor assembly (B) and long screws (AA):
a. Turn the housing lock (I) clockwise to unlock the
motor assembly (B) from the housing (A).
b. Remove three motor screws (CC) and then remove
the motor assembly (B).
c. Remove and discard three heat shrinkable sleeves
from the housing (A) and then remove and save
three long screws (AA).
d. Disconnect the motor power connector (H) from
the receptacle in the housing (A).
Hardware Used
• Long Screw
<I
Motor Screw
~)))))))))\))))I
))J))
Ill])))}]>
~
x3
x3
2. Remove the wire housing screw (FF) and then remove
the wire housing cover (J).
Hardware Used
G
Wire Housing Screw
~
X
1
For installing the fan in a new construction application
where drywall or ceiling material is not previously
installed (exposed joists are visible), proceed to NEW
CONSTRUCTION INSTALLATION INSTRUCTIONS on
page 7.
For installing the fan to a joist in an existing construction
application (you already have a ceiling installed and
have proper installation access from above the ceiling),
proceed to EXISTING CONSTRUCTION (JOIST/ABOVE
CEILING ACCESS APPLICATION) INSTALLATION
INSTRUCTIONS on page 10.
For installing the fan to a joist in an existing construction
application (you already have a ceiling installed and
DO NOT have proper installation access from above
the ceiling), proceed to EXISTING CONSTRUCTION
(BELOW CEILING APPLICATION) INSTALLATION
INSTRUCTIONS on page 15.
6
•
i
•
~UTILITECH"
J
Lowes .com
\:1 - · -