Troubleshooting - Ryobi PMC1412K Manual Del Operador

PROBLEM
Leak at nozzle or threaded hole
Misting kit will not spray
Loss of pressure
Water stuck in misting tube after use
NOTE: ILLUSTRATIONS START ON PAGE 8 AFTER FRENCH

TROUBLESHOOTING

POSSIBLE CAUSE
Nozzles were installed improperly.
Nozzles clogged or dirty.
Hose faucet is closed.
T-filter is clogged.
Nozzles clogged or dirty.
T-filter is clogged.
Debris in misting kit.
Leak in misting tube.
Misting tube connected to T-filter.
AND SPANISH LANGUAGE SECTIONS.
7 — English
SOLUTION
Reinstall nozzles and tighten securely.
Clean nozzles.
Turn hose faucet completely on.
Follow instructions for cleaning strainer
in Maintenance.
Clean nozzles.
Follow instructions for cleaning strainer
in Maintenance.
Follow instructions for flushing the
system in Assembly.
Replace misting tube.
Disconnect misting tube from T-filter
and allow water to drain.