Operating Elements And Connections - Monacor PA XA-380USB Manual De Instrucciones

All operating elements and connections de -
GB
scribed can be found on the fold-out page 3.
1 Operating Elements
and Connections
1.1 Upper side and front side of
the active speaker system
1 Reception LED RF ON; lights up when the
wireless microphone has been switched on and
set to the transmission channel of the active
speaker system
2 Volume controls MIC 1/ W MIC and MIC 2 for
microphones connected to the jacks MIC 1 and
MIC 2 (5)
The left control MIC 1/ W MIC is also used to
adjust the volume of the wireless microphone.
3 Button VOICE PRIORITY for the crosstalk func-
tion:
When the button is pressed, the signals of the
MP3 player and the input signals of the jack
AUX (7) will be faded out when an announce-
ment is made via the wireless microphone or via
a microphone connected to the jack MIC 1 (5).
4 Controls TREBLE and BASS
5 Jacks MIC 1 and MIC 2 (6.3 mm jack) to connect
microphones
6 Volume control AUX for a unit connected to the
jack AUX (7)
7 Input jack AUX (6.3 mm jack) to connect a unit
with line level output (e. g. CD player, cassette
recorder)
8 Output jack REC OUT (6.3 mm jack) to connect
a recorder or another amplifier
9 USB port to connect a USB flash drive
10 Display
11 Buttons
the next title. To select the previous folder or the
next folder, keep the button pressed until the
desired folder number is displayed (F . .).
12 Buttons VOL+ and VOL- for the volume of the
MP3 player
13 Button
(keep the button pressed until the display lights
up or is extinguished) and to stop the replay or
a recording (press the button briefly)
14 Slot for an SD / MMC memory card
15 Control LEVEL for the recording volume
To adjust the level, use the key (33) of the wire-
less microphone. The LED PEAK next to the
10
to select the previous title or
to switch the MP3 player on and off
control is used as an indication; it may only
briefly light up at the highest volume.
16 Button REC for the recording function
(chapter 5.1)
17 Button to switch between replay and pause
18 Button RPT to select a repeat function and to
replay in a random order
Basic setting, indication REP
continuous repeat of all titles
First press of the button, indication
repeat of the current title
Second press of the button, no indication REP
no repeat function
Third press of the button, indication REP
replay of the titles in a random order
19 Button SD / USB to switch between USB flash
drive and SD / MMC card
1.2 Rear side of the active speaker system
(cover plate removed)
20 Charging compartment for two batteries of
size AA
21 Channel selector switch RF1 CH SEL to set the
receiving channel for operation with the wireless
microphone [To turn it, use the adjusting key
(33) of the wireless microphone.]
22 Charge LEDs
AA SIZE
for batteries of size AA in the compartment
(20), left LED for the lower battery
9 V BLOCK
for a 9 V battery connected to the snap-on
contacts (29)
12 V
for the integrated 12 V battery (26)
23 Low-voltage jack (centre contact = positive
pole) to connect an external DC voltage supply
(12 – 15 V), e. g. car battery
A low-voltage plug with the dimensions 5.5 /
2.1 mm (outside / inside diameter) is required.
24 On-off switch POWER
left position I
Only the charger for the batteries is switched
on.
central position
The unit is completely switched off.
right position II
The unit is switched on. When the unit is oper-
ated with mains voltage, the integrated 12 V
battery (26) is charged with a low current.
25 Power LED ON; lights up when the switch
POWER (24) is in the position II
ALL
REP
1