Operating Elements And Connections; Remote Control; Safety Notes - IMG STAGELINE FM-200H Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

All operating elements and connections described
GB
can be found on the fold-out page 3.

1 Operating Elements and Connections

1.1 Hazer
1 Power LED (green)
LED keeps flashing
when the FM-200H is operated via remote con-
trol or via DMX controller
LED lights continuously
when neither remote control nor DMX controller
is connected
2 Heat-up LED (red), lights up while the hazer is
heating up
3 DIP switches to set the DMX start address
(
chapter 8.2)
or, if neither remote control nor DMX controller is
connected, to adjust the haze output (
Important: When operating the hazer via remote
control or via DMX controller, set switch 10 to the
left position (OFF).
4 Locking screw for the adjustable haze outlet
5 Locking screws for the mounting bracket (12)
6 DMX input (XLR, 3 poles) for operation via DMX
controller
7 DMX output (XLR, 3 poles) for connection to the
DMX input of another DMX-controlled unit
8 Jack REMOTE CONTROL ONLY for the supplied

remote control

9 Mains jack for connection to a socket (230 V~ /
50 Hz) via the supplied mains cable
10 Fuse holder; always replace a blown fuse by one of
the same type
11 Power switch
12 Mounting bracket
13 Tank cap
14 Window to check the fluid level in the illuminated
tank
1.2 Remote control
15 Control INTERVAL to adjust the haze output inter-
vals (5 – 140 seconds) in the timer mode
16 Yellow timer LED, lights up in the timer mode
17 Red LED CONT, lights up in the continuous mode
18 Yellow button TIMER to activate / deactivate the
timer mode
8
19 Control FAN to adjust the fan power
20 Control OUTPUT to adjust the haze output in the
timer mode and in the continuous mode
21 Standby LED (green LED); lights up when the
hazer has been heated up and is ready for use
22 Red Button CONT to activate / deactivate the con-
tinuous mode
23 Green button MANUAL for maximum haze output
while the button is kept pressed

2 Safety Notes

This unit corresponds to all relevant directives of the
EU and is therefore marked with
WARNING
chapter 6)
Please observe the following items in any case:
G
The unit is suitable for indoor use only. Protect it
against dripping water and splash water, high air
humidity and heat (admissible ambient temperature
range: 0 – 40 °C.
G
Do not place any vessel filled with liquid on the unit,
e. g. a drinking glass.
G
Do not operate the unit and immediately disconnect
the mains plug from the socket
1. if the unit or the mains cable is visibly damaged,
2. if a defect might have occurred after the unit was
dropped or suffered a similar accident,
3. if malfunctions occur.
In any case the unit must be repaired by skilled per-
sonnel.
G
Never pull the mains cable to disconnect the mains
plug from the socket, always seize the plug.
G
For cleaning the housing, only use a soft clean cloth.
Never use any liquid; it may get inside the unit and
cause damage.
G
No guarantee claims for the unit and no liability for
any resulting personal damage or material damage
will be accepted if the unit is used for other purposes
than originally intended, if it is not correctly installed
or operated, or if it is not repaired in an expert way.
The unit uses dangerous mains voltage
(230 V~). Leave servicing to skilled per-
sonnel only. Inexpert handling may
result in electric shock.
If the unit is to be put out of operation defini-
tively, take it to a local recycling plant for a
disposal which is not harmful to the environ-
ment.
.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

38.6450

Tabla de contenido