Operating Elements And Connections; Important Safety Notes - IMG STAGELINE FM-3004 Manual De Instrucciones

Please take out page 3. Then you can always
GB
see the operating elements and connections de-
scribed.

1 Operating Elements and Connections

1 Tank cap
2 POWER switch
3 Warning LED to indicate insufficient fog fluid
flashes green in intervals:
sufficient fluid in the tank
flashes red continuously:
fluid level is too low – switch off and refill the
fluid!
4 Jack for the remote control
5 Window to check the fluid level
6 Jack for the supply voltage 230 V~/50 Hz
7 Fuse holder; only replace a blown fuse by one of
the same type
8 INTERVAL control to adjust the time between two
fog outputs at activated timer operation
9 Yellow LED
lights up if the timer operation has been switched
on with the TIMER button (11)
10 Red POWER LED
lights up if the unit is connected to a mains socket
and is switched on
11 Yellow TIMER button to switch on the timer opera-
tion
12 VOLUME control to adjust the fog output quantity
with the timer operation switched on (yellow
TIMER button) or continuous operation (red CON'T
button)
Note: when pressing the green MANUAL button
(15) always the maximum fog quantity is emitted
13 Green LED
lights up when the heating-up process is finished
and fog can be emitted
14 Red CON'T button to switch on the continuous
operation
15 Green MANUAL button to emit the maximum fog
quantity as long as the button is kept pressed
16 Plug of the remote control for the connection to the
jack (4)
6

2 Important Safety Notes

This unit corresponds to the directive 89/336/EEC for
electromagnetic compatibility and to the low voltage
directive 73/23/EEC.
Attention! The unit is supplied with hazardous mains
voltage (230 V~). Leave servicing to skilled
personnel only. Inexpert handling may
cause an electric shock hazard. Further-
more, any guarantee claim will expire if the
unit has been opened.
It is essential to observe the following items:
The unit is suitable for indoor use only. Protect it
against dripping water and splash water, high hu-
midity, and heat (admissible ambient temperature
range 0 – 40 °C).
Do not place any vessels filled with liquid, e. g. drink-
ing glasses, on the unit.
The heat being generated in the unit has to be re-
moved via air circulation. Therefore, the air vents at
the housing must not be covered with any objects.
Do not insert or drop anything into the air vents! This
could result in an electric shock.
Do not set the unit into operation, and immediately
disconnect the mains plug from the mains socket if
1. there is visible damage to the unit or to the mains
cable,
2. a defect might have occurred after a drop or simi-
lar accident,
3. there are malfunctions.
The unit must in any case be repaired by skilled per-
sonnel.
Never pull the mains cable to disconnect the mains
plug from the mains socket.
For cleaning only use a dry, soft cloth, by no means
chemicals or water.
If the unit is used for purposes other than originally in-
tended, if it is not operated carefully or not repaired in
an expert way, there is no liability for possible damage.
If the unit is to be put out of operation definitively,
take it to a local recycling plant for disposal.
Important for U. K. Customers!
The wires in this mains lead are coloured in accord-
ance with the following code:
green/yellow = earth
blue = neutral
brown = live
As the colours of the wires in the mains lead of this
appliance may not correspond with the coloured
markings identifying the terminals in your plug, pro-
ceed as follows:
1. The wire which is coloured green and yellow must
be connected to the terminal in the plug which is
marked with the letter E or by the earth symbol
or coloured green or green and yellow.
2. The wire which is coloured blue must be con-
nected to the terminal which is marked with the
letter N or coloured black.
3. The wire which is coloured brown must be con-
nected to the terminal which is marked with the
letter L or coloured red.
Warning - This appliance must be earthed.
,