Dometic GROUP WAECO ColdMachine Serie Instrucciones De Uso página 42

Installing the cooling unit
No. in fig. 0,
page 6
1
No. in fig. a,
page 6
1
No. in fig. j,
page 9 and
fig. k, page 10
1
2
3
4
A
NOTICE!
Carefully insulate and seal off the wall openings after installation
to prevent moisture penetration.
For cooling units with valve couplings
➤ Cut out a hole with a diameter of at least 30 mm (fig. d, page 7) for the
cooling lines. To do this, use a circular cutter.
A
NOTICE!
Never bend the connecting line between the vaporiser and the
unit. The minimum bending radius is 25 mm.
42
Explanation
Drip tray
Explanation
Connection cable
Explanation
Connection block
Compressor
Fan
Switch fig. j or TEC controller fig. k
Coldmachine
EN