Safety Instructions - Mettler Toledo PBA426 Manual De Usuario

1
6
User Manual PBA426 / PBA426x
METTLER TOLEDO

Safety Instructions

Product safety plays an important role at METTLER TOLEDO.
Non-observance of the following instructions can lead to damage
to the weighing platform and/or injuries.
Read this manual carefully before operating or servicing
▲
this equipment.
Strictly observe these instructions and save this manual for
▲
future reference.
Only personnel trained and qualified by METTLER TOLEDO
▲
may install and maintain the weighing platform.
Be careful when transporting or lifting heavy devices.
▲
Always disconnect this device from the power source before
▲
installing, servicing, cleaning or performing maintenance.
Make sure the weighing platform reached room temperature
▲
before switching on the power supply.
The explosion-protected weighing platforms (PBA426x) are
▲
approved for operation in following hazardous areas:
ATEX Category 2, gas/dust (Zone 1/21) - FM I.S. Class I, II,
III Div. 1 (Load Cell FM approved)
There is an increased risk of injury and damage when the
▲
weighing platforms are used in hazardous areas! Special
care must be taken when working in such areas.
Explosion-protected weighing platforms may only be used
▲
in hazardous areas in conjunction with weighing terminals
with the appropriate approval and interface specification.
The connection cable may not be disconnected from the
▲
weighing terminal while energized.
In case of PBA426x only use cable glands that are suitable
▲
and approved for hazardous areas for inserting the weighing
cell cable into the service terminal.
Order number 72230073A 07/11