Setting The Water Hardness - Melita Caffeo Solo Manual De Instrucciones

Inserting the water fi lter
fl ashes during the entire changing
process.
• Put the water fi lter in a glass with
tap water for several minutes before
inserting it in the appliance.
• Switch off the appliance.
• Press and hold the
for ca. 3 seconds, then release.
appears on the display.
• Empty and insert the drip tray.
illuminates.
• Pull the water reservoir 6 up and out of
the appliance.
• Empty the water reservoir.
• Screw the water fi lter onto the thread at
the bottom of the water reservoir.
• Fill the water reservoir with fresh tap
water up to the max. mark.
• Insert the water reservoir into the
appliance.
• Press the button. The appliance
performs an automatic rinse. When
rinsing is fi nished, the appliance is ready
for operation and the water hardness is
set to hardness level 1.
• Empty and insert the drip tray.
After inserting the water fi lter, the water
can be cloudy during the fi rst rinse
because excess activated carbon is
washed out of the fi lter. The water then
becomes clear again.
BA_Solo_042015.indd 19 BA_Solo_042015.indd 19

Setting the water hardness

The appliance includes a test strip to
determine the water hardness.
• Determine the hardness of the tap water
using the test strip.
• Switch on the appliance.
• Press the
and buttons
simultaneously for longer than 2
seconds.
• Press the
for setting the water hardness.
illuminates.
• Set the determined water hardness by
pressing the
water hardness is shown by the bean
symbols
4:
• Press
and button
fl ashes rapidly.
button to show the menu
button. The selected
.
Water hardness °d
0 - 1 0
1:
10 - 1 5 13 - 1 9 18-27
2:
15 - 2 0 19 - 2 5 27-36
3:
> 20
fl ashing
to confi rm the selection.
°e °f
0 - 1 3 0 - 1 8
> 25 > 36
19
20.04.2015 21:30:46 20.04.2015 21:30:46