Battery Recharge And Replacement; Advanced Operations; Handset Registration - EnGenius FreeStyl 2 Manual De Usuario

2. To unlock the keypad, press the UNLOCK
then, within 2 seconds, press the digit "＊" to unlock.
3. Once returning back to standby mode for 15 seconds, the
Keyguard will automatically re-enable.
4. Key Guard is in effect until unlocked.

Battery Recharge and Replacement

1. Charge the battery when one or several of the following things happen:
a. Phone beeps twice (every 60 seconds in talk mode, every 10 minutes in
standby mode).
b. Battery icon is empty.
c.
Phone does not respond when a power on/off key
d. LCD and backlighting become dim.
e. Talk range shortfall is experienced.
2. You can replace the handset battery even while on an active phone call by
putting the call on-hold first and then by pressing the
call on hold, press the talk key again after replacing the battery and powering
the handset on.
3. Battery talk time and standby time vary depending on the talk/standby pattern
and the operating distance. Putting the handset back in the charger cradle as
often as possible is recommended for best performance.
manufacturer provided battery and charger!
(Left) soft key,
is pressed.
key. To retrieve the
Use only
~35~

Advanced Operations

Handset Registration

1. If your handset(s) is purchased as part of a system, it has been pre-registered
with the base station at the factory.
2. If Handset ID shows "00," that means it is a new handset or the ID has been
erased. You need to register the handset with the base station.
3. Registering Handsets:
a. Press MENU-7 to enter the registration section.
b. Press and hold the base's PAGE button for 3 seconds
until the In Use LED (white color) lights up and flashes;
The base station will produce a sound to remind you
the base station is in the registration mode.
c. Press handset key "1". This completes the registration
process. The base station will assign a handset ID
between 11 and 19 automatically. The assigned ID will
be displayed on the handset LCD, indicating successful
registration. If you get a "base has no available ID"
prompt, you will need to reset the base (see page 22).
d. Repeat above steps for all additional handsets.
4. De-registration:
a. You can de-register the handset you're using from the
base station. De-registration will reset the Handset ID
to 00, erase the system security code, and free up the
handset ID for future registration.(registrations of other
handsets)
b. After deregistration, the handset will not be able to use
the base station to make or receive phone calls, nor can
it intercom other handsets.
c. Press MENU-7 to enter the registration section.
d. Press and hold the base's PAGE button for 3 seconds
until the In Use LED (white color) lights up and flashes;
The base station will produce a sound to remind you
the base station is in the registration mode.
e. Press the handset number key "2". This completes the
de-registration process. Upon successful de-
~36~