Key Guard; Battery Recharge And Replacement; Advanced Operations; Handset Registration - EnGenius FreeStyl 1 Manual De Instrucciones

2. For temporary silencing the ringer when an incoming
call arrives, press SILENT (Left) soft key.

Key Guard

1. To prevent accidental dialing, you can press
(Right) soft key, then press "＊" to select KeyGuard
option. The handset keypad is locked. No key entry is
accepted.
2. To unlock the keypad, press UNLOCK
then, within 2 seconds, press the digit "1" to unlock.
3. Key Guard is in effect until unlocked.

Battery Recharge and Replacement

1. Charge the battery when one or several of the following happen:
a. Phone beeps twice every two seconds.
b. Battery icon is empty.
c. Phone does not respond when a key is pressed.
d. LCD and backlighting become dim.
e. Talk range shortfall is experienced.
2. You can replace the handset battery after placing the call-in-progress on
hold.
3. Battery talk time and standby time vary depending on the talk/standby
pattern and the operating distance. Putting the handset back to charger
cradle as often as possible is recommended for best performance. Use
only manufacturer provided battery and charger!
MENU
(Left) soft key,
~35~

Advanced Operations

Handset Registration

1. If your handset(s) is purchased as part of a system, it has been pre-
registered with the base station at the factory.
2. If Handset ID as "00," that means it is a new handset or the ID has been
erased. You need to register the handset with the base station.
3. Registration:
a. Press MENU-7 to enter the registration mode
b. Press and hold the base's Registration (REG)
button for 2 seconds until the
lighting up and flashing, also the base will emit
ringing to remind you the base is in the registration
mode..
c. Press handset key "1", this completes the
registration process. The base station will assign a
handset ID between 12 and 19. The assigned ID
will be displayed on the handset LCD, indicating
successful registration.
d. Repeat above steps for all additional handsets.
4. De-registration:
a. You can de-register the handset you're using from
the base. De-registration will reset the Handset ID
to 00, erase the system security code, and free up
the old ID for future registration.
b. After deregistration, the handset will not be able to
use the base to make or receive phone calls, nor
can it intercom other handsets.
c. Press MENU-7 to enter the registration mode
d. Press and hold the base's REG button for 2
seconds until until the and
up and flashing.
e. Press the handset number key "2", this completes
the de-registration process. Upon successful de-
registration, the handset will show ID "00".
and LEDs
LEDs lighting
~36~