Placing A Call On Hold; Mute; Do Not Disturb (Silent Ring); Key Guard - EnGenius EP801 Manual De Usuario

Placing a Call On Hold

1. When a call is in progress, it can be put on hold by
pressing the key.
2. To return to the conversation, press
soft key
Notes:
1. The call being placed on hold can be "un-hold" by the handset
that puts it on hold. But if the handset press
standby, then other handsets can press
this held call (If press
call).
2. Handset LCD displays a call is being on hold. An alert tone
(double beep) every 30 seconds will remind the handset that a
call is being on hold.
3. If the operation (e.g., call transfer) after putting a call on-hold
fails, the held call may be dropped.

Mute

1. After a link is established, you can press
soft key to mute the handset microphone.
2. When mute is active, the other end will not hear your
voice, but still can speak to you.
3. To leave the mute state, press
key. Mute is effective only for the current call.

Do Not Disturb (Silent Ring)

1. Enter the key sequence MENU-3-1, then select "Off".
Press SELECT (Left) to confirm your choice. This will
turn off the ringer until it is turn on again from the
menu.
Re: When setting the ringer "Off", the standby screen
UNHOLD (Left)
key to go back
or to pick
on base, it can also pick up this held
MUTE (Left)
UNMUTE (Left) soft
~33~
will show "Ringer off".
2. For temporary silencing the ringer when an incoming
call arrives, press SILENT (Left) soft key.

Key Guard

1. To prevent accidental dialing, you can press
(Right) soft key, then press "1" to select KeyGuard
option. The handset keypad is locked. No key entry is
accepted.
2. To unlock the keypad, press UNLOCK
then, within 2 seconds, press the digit "＊" to unlock.
3. Key Guard is in effect until unlocked.

Battery Recharge and Replacement

1. Charge the battery when one or several of the following happen:
a. Phone beeps twice every two seconds.
b. Battery icon is empty.
c. Phone does not respond when a key is pressed.
d. LCD and backlighting become dim.
e. Talk range shortfall is experienced.
2. You can replace the handset battery after placing the call-in-progress on
hold.
3. Battery talk time and standby time vary depending on the talk/standby
pattern and the operating distance. Putting the handset back to charger
cradle as often as possible is recommended for best performance. Use
only manufacturer provided battery and charger!
MENU
(Left) soft key,
~34~