After Self-Cleaning - Maytag T2 Guia Del Usuario

temperatures and should be cleaned to
prevent soil from baking on during the
clean cycle.
To prevent damage, do not clean or
rub the gasket around the oven door.
The gasket is designed to seal in heat
during the clean cycle.
Wipe up excess grease or spillovers from
the oven bottom to prevent excessive
smoking, flare-ups or flaming during the
clean cycle. For ease of cleaning, the
heating element can be lifted slightly
(1 inch).
Wipe up sugary and acidic spillovers
such as sweet potatoes, tomato or milk-
based sauces. Porcelain enamel is acid
resistant, not acid proof. The porcelain
finish may discolor if acidic spills are not
wiped up prior to a self-clean cycle.
DURING CLEAN CYCLE
When the LOCK indicator word lights in
the display, the door cannot be opened.
To prevent damage to door, do not force
door open when the LOCK indicator word
is displayed.
Some smoke and odor may be detected
the first few times the oven is cleaned.
This is normal and will lessen in time.
Smoke may also occur if oven is heavily
soiled or if broiler pan was left in oven.
As oven heats, you may hear sounds of
metal parts expanding and contracting.
This is normal and will not damage the
oven.

AFTER SELF-CLEANING

About one hour after the end of the clean
cycle, the LOCK indicator word will turn
off. At this point, the door can be opened.
Some soil may leave a light gray, pow-
dery ash which can be removed with a
damp cloth. If soil remains, it indicates
that the clean cycle was not long enough.
The soil will be removed during the next
clean cycle.
If the oven racks were left in the oven and
do not slide smoothly after a clean cycle,
wipe racks and embossed rack supports
with a small amount of vegetable oil to
restore ease of movement.
A white discoloration may appear after
cleaning if acidic or sugary foods were
not wiped up before the clean cycle. This
discoloration is normal and will NOT
affect performance.
Fine lines may appear in the porcelain result-
ing from the heating and cooling of the finish.
This is normal and will not affect perform-
ance.
SETTING THE CONTROLS
FOR SELF-CLEAN
1. Close oven door.
2. Press Clean pad.
CLEAN will flash and "– –:– –" will
light in the display.
If door has not been closed, "door"
will light in the display and a signal
will beep until the door is closed
and the Clean pad is pressed
again.
3. Press Preset (0) pad for "3:00" hours
of cleaning time for an average soiled
oven. Or, press the appropriate num-
ber pads for the desired cleaning time
between two and four hours.
4. Four seconds after entering the clean-
ing time, the oven door will automati-
cally lock.
LOCK will appear in the display.
Clean symbol will appear in
the display.
0 0 0
03:00 HR
BAKE
LOCK
DELAY COOK STOP TIMER CLEAN ROAST BROIL
5. When the cleaning time has been
completed, the indicator word CLEAN
will turn off. The indicator word LOCK
will remain on until the oven has
cooled (approximately 1 hour).
3 5 0
When the oven has cooled, the indica-
tor word LOCK will turn off and the
door will automatically unlock.
°
3 5 0
HR
10 :00
BAKE
LOCK
DELAY COOK STOP TIMER CLEAN ROAST BROIL
LOCK IS STILL ENGAGED.
DOOR CANNOT BE
OPENED UNTIL LOCK IS
NO LONGER DISPLAYED.
TO CANCEL SELF-CLEAN CYCLE:
Press CANCEL pad.
If the indicator word LOCK is NOT dis-
played, open oven door. If LOCK is
displayed, allow oven to cool, then
open oven door.
NOTE: Depending on the length of
time the oven had been cleaning, it
may take up to an hour for the oven to
cool down. When the oven is cool, the
door will automatically unlock and can
be opened.
IF YOU WISH TO DELAY THE START
OF CLEANING:
1-3. Follow preceding steps 1-3.
4. Press the Stop Time pad.
Stop Time will flash in the display
and display will show calculated
stop time based on the current time
of day and the clean time prev-
iously entered.
5. Press the appropriate number pads to
enter the time you wish the oven to
stop. A stop time can only be accepted
for later in the day.
EXAMPLE: If at 9:00 you set the
oven to clean for three hours, the cal-
culated stop time would be "12:00".
If you want the stop time to be 1:00,
press the number pads "1,0,0".
°
Four seconds later, the display will
show 1:00 and the indicator word
DELAY.
6. When the oven begins to clean, the
CLEAN symbol will light and DELAY
will go off in the display.
7. When the clean time has been com-
pleted, the indicator word CLEAN will
turn off. The indicator word LOCK will
remain on until the oven has cooled.
When the oven has cooled, the indica-
tor word LOCK will turn off and the
door will automatically unlock.
14