Default Parameters - REBER 9340 N Manual De Uso

USE OF THE MACHINE
-Place the product and connected cord so that it is not likely that the product will be
overturned. -Introduce the supply cable plug into a socket with suitable voltage. The unit is
ready for operation.
Cod. 9700 N (F) FAMILY - Cod. 9701 N (F) FAMILY DE LUXE AUTOMATIC
- By pressing starting switch (1.) the unit starts the automatic working cycle: vacuum is
produced in the bag/container and welding is carried out without any operator's
intervention. When the cycle is completed the unit stops automatically.
- The unit is equipped with a vacuum gauge which makes welding start as soon as a
depression of about -700 mbar is reached.
- Manual operation is also possible to have welding carried out before the set depression
is reached (for example, to prevent some products from being smashed), or to prolong
pump operation and obtain higher vacuum levels.
-
SEAL POWER SETTING
1- With the appliance connected to the power supply
2- Push 10 times in 10 seconds the seal switch (2),
3- Push the pump switch (1) once per each unit of time/power you need ( default set is 5 units),
4- If pushing on pump switch (1), the pump start, it means the cycle was not correct, re-start
from point 1
5- Wait 10 seconds to start working normally with new seal power set
6- New set will remains in memory of the machine even if you disconnect the machine from
power supply.
Default sealing time is 5 time/power units
Be careful! don't set more then 9 time/power units or the teflon protection of the sealing bar
can burns

DEFAULT PARAMETERS:

Disconnect the unit
Press and keep pressed the two switches
Connect the unit and wait 5 sec. with the switched pressed
SWITCH FROM AUTOMATIC FUNCTIONNING TO MANUAL:
Disconnect the unit
Press and keep pressed the ON/OFF switch
Connect the unit and wait 5 sec. with the switched pressed
SWITCH FROM MANUAL FUNCTIONNING TO AUTOMATIC:
Disconnect the unit
Press and keep pressed the WELDING switch
Connect the unit and wait 5 sec. with the switched pressed
VACUUM PACKAGING IN BAGS
- Introduce the product into a bag suitable for vacuum preservation; leave at least 5 cm free
room from bag opening.
101