Manual Use - REBER 9340 N Manual De Uso

5- Wait 10 seconds to start working normally with new seal power set
6- New set will remains in memory of the machine even if you disconnect the machine from
power supply.
IMPORTANT: we suggest not to set welding time over 15 time/power units.
SUGGESTED TIMES OF WELDING
Bag thickness
95 - 105 micron
145 - 155 micron
INFO:
Sealing time could be different using different kind of bags even if thickness is the same;
we suggest to test welding after changing welding time.
IMPORTANT
If the machine is not used for a long period and/or in the case of non-adequate or low
temperatures, it is recommendable, before using the machine, to try it once without using
the bag and keep the machine working in vacuum conditons for some seconds.
AUTOMATIC USE
1) Put the food which is to be vacuum preserved in a bag of adeguate size, leaving about 5
cm from the edge of the bag and the food.
2) Lift the cover up (4).
3) Place the open side of vacuum bag in the vacuum chamber (6), between the gaskets
(5). 4) Close the cover and press pump switch (1). This will start vacuum operation.
5) As soon as vacuum pump starting, slightly press with both hands the cover so as it
sticks to the surface of the bag. After a few seconds the depression created by the pump
will permit to release the cover, while the machine will keep on suction.
USER INTERVENTION
Every operation will stop when pressing pump switch (1).
User can start welding operation, by pressing welding switch (2), during vacuum operation.
User can change from automatic to manual use, during vacuum operation, by pressing and
holding pump switch (2); in this case welding operation should be manually operated by
pressing welding switch (2).

MANUAL USE

1) Put the food which is to be vacuum preserved in a bag of adeguate size, leaving about 5
cm from the edge of the bag and the food.
2) Lift the cover up (4).
3) Place the open side of vacuum bag in the vacuum chamber (6), between the gaskets
(5).
4) Close the cover and press pump switch (1). This will start vacuum operation.
5) As soon as vacuum pump starting, slightly press with both hands the cover so as it
sticks to the surface of the bag. After a few seconds the depression created by the pump
will permit to release the cover, while the machine will keep on suction.
6) The indicator on red shows that the right vacuum level is reached.
Welding Time
4 / 5
12 / 15
104