Before First Use - ECG PH 6520 Manual De Instrucciones

CAUTION! TO PREVENT DAMAGE OR SHOCK HAZARD DO NOT COOK IN
THIS LINER. COOK ONLY IN THE PROVIDED VESSEL. DO NOT IMMERSE IN
LIQUID. – CAUTION! RISK OF DAMAGE OR INJURY: NEVER PUT FOODS
DIRECTLY INTO THE BODY OF THE APPLIANCE. ONLY USE ORIGINAL
INTERNAL CERAMIC VESSEL FOR COOKING. DO NOT IMMERSE IN WATER
OR ANY OTHER LIQUID!
WARNING:
1. Neither the glass lid nor the ceramic vessel are suitable for the
dishwasher.
2. Never put the hot ceramic vessel or lid in the refrigerator, they may
crack.
3. After removing them from the refrigerator, leave the ceramic vessel
and the lid for about 40 minutes at room temperature. Do not use
immediately, they could break. The internal vessel must always be
dry before you insert it in the base.
4. Never put the ceramic vessel on hot stove, it could crack.
5. The ceramic vessel should not be used for cooking in an oven,
microwave or on a stove or hob.
6. Do not place the ceramic container or lid in the freezer.
7. Please do not heat frozen food in the slow cooker.
8. Do not turn on an empty appliance (without food) and do not
overfill it.

BEFORE FIRST USE

Remove all packaging material. Clean and dry the appliance carefully, see chapter "Cleaning and maintenance".
Do not immerse the base of the cooker in water. Do not wash the ceramic pot and the lid in the dishwasher. Do
not use sharp tools or aggressive or abrasive cleaning agents.
Note: You may notice a slight odor or smoke when you use it for the first time. This is normal with most
appliances with heating elements and does not present any danger. This occurrence disappears in time.
Turning the appliance On/Off
Insert the ceramic pot into the appliance and make sure it fits well in the base.
Turning the appliance on: Plug the pot into the mains. The display shows "- - - -".
Press the START /STOP button once to turn on the unit. The display shows "00:00".
Turning the appliance off: Press again the START/STOP button to turn off the appliance and the display shows
again "- - - -". Unplug it from the mains to turn it off completely.
Temperature mode
The temperature setting mode can be set using the HIGH /LOW /WARM button.
8