Maintenance; Recommended Lubricants; Cleaning And Maintenance; Cleaning Intervals - Bosch TCE 4460 Instrucciones De Reparacion

en 58 | TCE 4460-TCE 4465 | Maintenance
5.

Maintenance

5.1

Recommended lubricants

Component Lubricant
Mineral
Gear unit
lubricating oil
Compressed air sys- Mineral
tem lubricating oil
Tab. 3: Lubricant table
i The manufacturer does not accept any responsibility
for damage caused by the use of lubricants not com-
plying with these standards.
5.2

Cleaning and maintenance

Prior to cleaning or maintenance, always switch
off the
mains connector.
The
compressed air supply prior to cleaning or
maintenance.
Regular cleaning and maintenance of the
to ensure maximum performance and proper operation.
Maintenance work must be performed by the operator on
the basis of the manufacturer's specifications as follows.
5.2.1

Cleaning intervals

|
1 695 100 278 2013-12-03
The illustration shows the areas where cleaning is re-
quired to ensure maximum performance of the machine.
Standard
ISO 460
DIN 51502-CLP
ISO 34-98-CC
ISO VG 32
at the master switch and unplug the
must always be disconnected from the
Fig. 59:
are essential
Area
A
B
C
D
Tab. 4:
Machine cleaning areas
Cleaning method
Use cleaning agent and lubricating
spray.
Clean with a cloth and check the con-
dition of the protective equipment.
Use cleaning agent and lubricating
spray.
Check the condition of the rubber
guard (wear, contamination)
Cleaning intervals
x
x
x
x
Robert Bosch GmbH