Battery Replacement - Benning CM 9 Instrucciones De Servicio

9.3 Battery replacement

Before opening the BENNING CM 9, make sure that it is free of

voltage! Electrical danger!
The BENNING CM 9 is supplied by means of two 1.5-V micro batteries/ type
AAA (IEC LR 03).
A battery replacement (see Figure 9) is required, if the battery symbol 5 ap-
pears on the display 3. When the BENNING CM 9 is switched on, a battery
test is performed.
Proceed as follows to replace the batteries:
- Switch the BENNING CM 9 off.
- Put the BENNING CM 9 face down and unscrew the screw of the battery
compartment cover.
- Lift off the battery compartment cover (in the area of the housing slots) from
the bottom part of the battery compartment.
- Remove the discharged from the battery compartment.
- Then, insert the new batteries into the battery compartment at the provided
places (please observe correct polarity of the batteries).
- Lock the battery compartment cover into place on the bottom part and tight-
en the screw.
see figure 9:
Make your contribution to environmental protection! Do not
dispose of discharged batteries in the household garbage.

Instead, take them to a collecting point for discharged batteries
and special waste material. Please inform yourself in your
community.
9.4 Calibration
Benning guarantees compliance with the technical and accuracy specifications
stated in the operating manual for the first 12 months after the delivery date.
To maintain the specified accuracy of the measurement results, the instrument
must be recalibrated at regular intervals by our factory service. We recommend
a recalibration interval of one year. Send the appliance to the following address:
BENNING Elektrotechnik & Elektronik GmbH & Co. KG
Service Centre
Robert-Bosch-Str. 20
D - 46397 Bocholt
10. Environmental note
At the end of the product's useful life, please dispose of the device at
collection points provided in your community.
06/ 2016
battery replacement
BENNING CM 9

12