Installation; Requirements For Installation - Protec ECOMAX Manual De Instrucciones

Tabla de contenido

Idiomas disponibles

Installation

Fresh water connection: Shut-off tap, thread with 3/4" outside diameter (wash-

ing machine connection), Water pressure 2 - 10 bar (29 - 145 psi).

Drainage connection: Plastic tube - inner diameter 50 mm (2") or larger. A

ventilated syphon which serves as odour preventor should be included in the

planning. The drainage tubes should be installed with a decline of

minimum 5 %. Local Water Authorities regulations should be complied with.

Electrical connection: Fused wall socket with earth connection according to

electrical data (see technical specifications, page 11). It is also required to

install an earth-leakage switch (with 25 A / 30 mA nominal error current).

Electrical connections should be carried out according to reg-

ulations by an electrician.

2. Transport

Due to the weight and dimensions of the film processor ECOMAX

be carried by two persons. To do so, hold the machine on the sides of the bottom

pan (see figure). While putting the machine down, watch the position of the levelling

feet to prevent damaging these.

3. Set-Up

Unpack the Processor. Remove light protection cover and machine cover, remove

roller racks, begin with the developer roller rack (red).

Remove the brackets for film output from the packaging and press them into the

openings on the rear of the film output until they snap into place. Be sure the long

side of the bracket points inward and touches the film output on top (see figure).

Table-top installation

In the event that the processor is to be installed on a work top or table, the four ad-

justable feet should be screwed on.

Attention!

Machine should not be installed on table-top without adjusta-

ble feet. The ventilation openings on the underside and at the

rear of the unit must not be covered, as this may lead to over-

heating of the machine.

Unit with Worktable

If the unit is set up on a worktable (optional accessory), the unit should be screwed

to the worktable. Mount the unit as outlined in the manual (included with the workta-

ble).

Finally the processor needs to be levelled:

Place spirit level across the walls of the baths and adjust the levelling feet accord-

ingly (on the unit itself or on the worktable). Reinstall the roller racks in the unit and

lock them; begin with the dryer roller rack.

should always

ECOMAX

Tabla de Contenido

Tabla de contenido