Care; Daily Care; Weekly Care; Thorough Cleaning - Protec ECOMAX Manual De Instrucciones

Care

Care

Daily Care

Before use...
• Remove dirt and dust from film-infeed with soft cloth.
• Run 2 - 3 cleaner films through the processor to remove all accumulated dirt
and dust from the rollers.
• Check the liquid level in the replenishment containers and if necessary refill.
• Leave light protection cover open when no film is in the processor. This avoids
condensation on infeed.
After use...
• When work has been completed at the end of the day, drain water out of the
machine. This avoids the growth of algae in the water.
Attention: Do not allow liquids to enter the interior of the unit.
Liquids may cause damage to the processor.

Weekly Care

The developer chemicals cause residue buildup in the machine. This residue has a
negative effect on the developing process of the film material. For this reason the
processor should be regularly cleaned. Proceed as follows:
1. Switch the machine off, lift of light protection cover and cover.
2. Loosen the securing latches of the roller racks (red, blue and beige) on the
drive shaft.
3. Remove the roller-racks. First remove the developer rack (red). Then remove
the fixer (blue) and dryer (black) racks one after the other. The roller racks of
the developer and the water bath can be removed and inserted easier if you
tilt them a little.
4. Rinse all racks thoroughly under warm running water and then leave to drain
off. Use a soft sponge (do not use scouring-pad, as this would scratch the roll-
ers!) and remove the pollution from the rollers.
5. Replace the racks: Red = Developer, Blue = Fixer. Black = rinsing/dryer.
Begin with the dryer, proceed with the fixer and last insert the developer rack.
Ensure that the racks are properly placed and do not forget to lock the drive
shafts.
6. Re-install machine cover and light protection cover; be sure these are prop-
erly placed; check that the machine cover actuates the cover switch.
7. Clean processor outer shell with damp cloth. Do not use aggressive cleaners
or solvents.
Important notes:
When removing the rinsing / drying roller-rack, ensure that no
water gets into the film dryer air channel.
For removal, the rinsing / drying roller-rack must first be
turned toward the film output, then it can be lifted out.

Thorough Cleaning

Every three months (maybe earlier) a thorough cleaning is necessary, depending
on the quantity of films processed. Tank cleaners are available for developer and
water baths. The fixer bath is cleaned with water. When preparing chemical tank
cleaners, follow manufacturer's instructions explicitly.
ECOMAX
TM
20