Wolf Garten GT-S 2-31 Instrucciones De Funcionamiento página 19

Installing the cutting blade
4. Remove the cutting attachment guard. See Removing
and installing the cutting attachment guard.
5. Place the cutting blade on the drive shaft (Fig. 14).
6. Centre the cutting blade on the drive shaft housing
(Fig. 14).
7. Ensure that the cutting blade is centred and is situated
flat against the drive shaft housing.
8. Align the shaft bush hole with the slot for the safety bar
and guide the safety bar into the shaft bush hole (Fig. 11).
9. Attach the blade holder and nut to the drive shaft
(Fig. 14). Check that the blade has been installed
properly.
10. While holding the safety bar, tighten the nut anti-
clockwise (Fig. 15). – Tightening torque 37 Nm –.
z If you do not have a torque wrench, turn the nut against
the blade holder until it is situated firmly on the shaft
bush. Check that the blade has been installed properly
and then turn the nut anti-clockwise a further ¼ to ½ turn
(Fig. 15).
11. Remove the safety bar from the safety bar slot.
12. Remove the guard from the cutting blade.
INSTALLATION MANUAL
REMOVING THE CUTTING BLADE AND
INSTALLING THE CUTTING ATTACHMENT
Removing the cutting blade
1. Attach the guard to the cutting blade.
2. Align the shaft bush hole with the slot for the safety bar
3. Hold the safety bar in place by gripping it together with
4. While holding the safety bar, loosen the nut on the blade
5. Remove the nut, blade holder and blade. Keep the nut
Installing the cutting attachment
6. Align the shaft bush hole with the slot for the safety bar
NOTE: The blade holder must be installed on the drive
7. Remove the safety bar.
8. Install the cutting attachment guard. See Removing
and guide the safety bar into the shaft bush hole (Fig. 11).
the shaft of the unit (Fig. 12).
by turning it clockwise with a screw key or socket
wrench (Fig. 16).
and blade together in a secure location for subsequent
use. Keep them out of the reach of children.
and guide the safety bar into the shaft bush hole (Fig. 11).
Place the blade holder on the drive shaft with the flat
surface against the drive shaft housing (Fig. 13). Rotate
the cutting attachment anti-clockwise onto the drive
shaft. Tighten firmly.
shaft in the illustrated position, otherwise the cutting
attachment will not function properly.
and installing the cutting attachment guard.
19