Wolf Garten GT-S 2-31 Instrucciones De Funcionamiento página 23

CHANGING THE SPARK PLUG
Use a Champion RDJ7Y spark plug (or an equivalent
spark plug). The correct electrode gap is 0,63 mm.
Every 50 operating hours take out the spark plug and
check its condition.
1. Stop the engine and leave it to cool down. Grip the spark
plug cable firmly and pull the cap off the spark plug.
2. Remove dirt from around the spark plug. Rotate the
spark plug to the left and remove it from the cylinder
head.
3. Replace a cracked, sooted or dirty spark plug. Using
a feeler gauge, adjust the electrode gap to 0,63 mm
(Fig. 37).
4. Install a spark plug in the cylinder head at the correct
electrode gap. Torque 12.3 – 13.5 Nm. Do not tighten
too tightly.
CLEANING
Use a small brush for cleaning the outside of the unit. Do not
use abrasive detergents. Household cleaners which contain
aromatic oils such as pine oil or lemon as well as solvents
such as kerosene may damage the plastic housing and
handle. Wipe damp areas with a soft cloth.
STORAGE
z
Never store the unit with fuel in the tank or where fumes
are within reach of a spark or naked flame.
z
Before storing the unit, leave the engine to cool down.
z
Store the unit locked away or high up to prevent
unauthorised use and damage. Keep the unit away from
children.
LONG-TERM STORAGE
If the unit is to be stored for a prolonged period, proceed
as follows:
1. Drain all the fuel out of the tank and pour into a container
with the same two-stroke mixture. Do not use fuel which
has been stored for longer than 60 days.
2. Start the engine and leave running until it stops.
This ensures that there is no fuel left in the carburettor.
3. Leave the engine to cool down. Take out the spark plug
and pour 30 ml of a high-quality engine oil or two-stroke
oil into the cylinder. Slowly pull the starter rope to
distribute the oil. Reinstall the spark plug.
NOTE: Before starting the lawn trimmer after storage, take
out the spark plug and pour all the oil out of the cylinder.
4. Thoroughly clean the unit and check for loose and
damaged parts. Repair or replace damaged parts and
tighten loose screws, nuts and bolts. The unit can now
be stored.
5. Store the unit locked away or high up to prevent
unauthorised use and damage. Keep the unit away from
children.
MAINTENANCE AND REPAIR
TRANSPORTATION
z
Before transporting the unit, leave it to cool down.
z
Empty the fuel tank before transporting the unit!
Filler cap must be closed tightly.
z
Secure the unit to prevent it from shifting during
transportation.
WARRANTY
The warranty regulations issued by our company or the
importer are valid in all countries. We shall repair any faults
on your unit free of charge in accordance with the warranty,
provided the fault was due to defective materials or manu-
facturing. If claiming under the warranty, please contact your
seller or your nearest branch.
23