baltur BTG 15 Manual De Instrucciones página 41

FAN ASSEMBLY DIAGRAM
USE OF THE BURNER
The burner operates fully automatically, therefore it is non necessary to carry out any kind at adjustment during
its operating. The "block" position is a safety position reached by the burner automatically when some of the com-
ponents of the burners or the plant do not work properly. It is necessary to check then whether the cause to the
problem is a dangerous one before unblocking the burner. The causes to the block may be temporary, for example
when air in inside the pipes. When it is unblocked, the burner starts operating properly.
If the burner stops three or four times at a stretch, it is necessary either to loock for the problem and solve it or
ask for the intervention of the after sales service.The burner can remain in the "block" position without any limit in
time. In emergency cases it is advisable to close the fuel valve, and to disconnect the burner electrically.
ONE STAGE NATURAL GAS BURNERS
- Observe the measurements indicated in the diagram
when fi tting the fan.
39 / 87
0006080876 ed 2007/02
1 Ionisation electrode
2 Ignition electrode
3 Flame disk
4 Gas diffuser
5 Gas delivery pipe
A B
BTG 28 5 2÷3
N° 0002934540
Rev.04/04/2005
C
5