Operating Instructions; Hose Hook-Up & Inlets - CycloVac Tradition Manual Del Propietário

Hose Hook-up & Inlets
Before operating your central vacuum...
Please verify that it is properly connected to the piping system, and to a grounded
electrical outlet, and that the low voltage wires are connected to the unit (see
pages 8 to 16). Then read the complete owner's manual and proceed with a quick
verifi cation of your unit's installation:
• Check fi lters to be sure they are properly installed.
• Check rubber seals in each vacuum inlet.
• Plug the hose alternatively into each vacuum inlet, to ensure that each one
works properly.
• While the hose is still plugged into one inlet and the system is operational,
check other inlets for leaks.
To start your central vacuum, simply insert the hose in the vacuum inlet of your
choice. Please ensure that the tab on the hose end is properly lined up with the
slot in the inlet opening (fi gure 16). If your hose handle has an integrated on/off
switch, simply slide the switch to the "on" position.
Do not try to open another inlet while your system is in operation, as it may
damage the inlet's rubber seal.
18
fi gure 16

Operating Instructions