Troubleshooting; General Information - CycloVac Tradition Manual Del Propietário

General Information

If the vacuum unit does not work, check the fuse or breaker on the unit and/
or in the electrical panel in your home, and replace any defective part(s) as
deemed necessary. Please verify that the unit has been installed properly,
according to the instructions in this manual.
Your vacuum cleaning system is designed to collect everyday dry matter
(dust). It is approved by authorized testing agencies for dry use only. Do not
use on wet surfaces.
Should you accidentally vacuum liquids, immediately unplug the unit from the
electric outlet, then empty and wipe the dust recipient with a dry cloth. Then
operate the system from the vacuum inlet through which you vacuumed the
liquid, in order to eliminate all moisture in the piping system.
We strongly recommend against vacuuming abrasive materials such as
cement, plaster and gyproc dust. This fi ne dust could work its way into
the motor, causing considerable damage. Should you do so inadvertently,
immediately clean the fi lters and, as a precautionary measure, contact your
authorized service center to determine the extent of the damage to the unit.
Remember that in order for your warranty to remain valid, maintenance of
the motor and repairs to the unit itself must be carried out by an authorized
service center, using original Cyclo Vac or Trovac parts.

Troubleshooting

27