Filters - CycloVac Tradition Manual Del Propietário

We recommend regular maintenance of the
fi ltration system, in order to ensure your
central vacuum's maximum performance.
Your Cyclo Vac central vacuum is equipped
with two fi lters. An anti-clogging fi lter
(thin fabric) stops the larger particles,
and a Cyclofi ltre (thick fabric) catches
the microscopic particles and is treated
with Ultra-Fresh* to prevent the growth of
mold, fungus and bacteria. Both fi lters are
washable in cold water (no bleach). Dry at
low temperature.
To remove the fi lters, fi rst remove the dust
receptacle (fi gure 19), then use the straps
at the base of the fi lters to withdraw them
(fi gure 20). We recommend that you clean
the anti-clogging fi lter (thin fabric) every
time you empty the dust receptacle. You
may either shake it out, or wash it. The
Cyclofi ltre (thick fabric) should be cleaned
after four anticlogging fi lter cleanings, or
approximately once a year.
It is important that both fi lters be
completely dry before they are reinstalled.
They should be carefully installed in the
support grooves (fi gure 21) on the fi lter
frame to ensure adequate protection for
the motor. Install the Cyclofi ltre (thick
fabric) fi rst, and the anticlogging fi lter (thin
fabric) over it.
Before replacing the fi lters, inspect them
for tears or punctures. Do not reinstall
damaged fi lters.
*Ultra-Fresh is a trademark of Thomson Research Associates.
Maintenance

Filters

(Except E100 Model)
fi gure 19
fi gure 20
fi gure 21
25