Maintenance Suggestions Module - CycloVac Tradition Manual Del Propietário

Maintenance Suggestions Module

Cyclo Alert
Your unit is equipped with an electronic
timing board that will suggest, by the
color of the blinking LED, the type of
maintenance that should be done. These
signals are only suggestions and do
not indicate a problem with your unit.
Your central vacuum will work normally
despite the fl ashing LEDs. When you
initially connect your unit, the LEDs will
be green and steady. When the LEDs
on the hose handle blink, no matter the
color, refer to the unit itself for status. It
may be time to change the fi lters, empty
the dirt receptacle and/or have the
motor(s) inspected.
Blinking green
• We suggest you clean the fi lters and empty the dirt receptacle.
Blinking amber
• We suggest that you change the fi lters.
Blinking red
• We strongly suggest you change the fi lters (if it was not done previsously)
and have an authorized service center inspect the motor(s). A tune-up
may be required.
Blinking green / amber / red
• It is time to bring your unit to an authorized service center. Your unit
has accumulated a considerable number of hours, and may require
maintenance. A complete inspection is therefore strongly recommended.
To reset the electronic timing board
• Hold the reset switch for 10 seconds.
20 Operating Instructions
(DL Series Only)
Reset
LED
Low
voltage