Operating Elements And Connections - Monacor MT-200 Manual De Instrucciones

Please unfold page 3. Then you can always see the operating
GB
elements and connections described.
Contents
1 Operating Elements and Connections . . . . . . . . . . . . . . . . 12
2 Safety Notes . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13
3 Applications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13
4 Setting into Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14
5 Carrying out Measurements . . . . . . . . . . . . . . . . . . . . . . . 14
5.1 Voltage measurement . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15
5.2 DC current measurement . . . . . . . . . . . . . . . . . . . . . . . . . 15
5.3 Resistance measurement . . . . . . . . . . . . . . . . . . . . . . . . . 16
5.4 Continuity check . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .16
5.5 Decibel . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17
5.6 Battery test . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17
5.7 Transistor test (with model MT-300 only) . . . . . . . . . . . . . . 17
6 Replacing of Batteries or Fuse . . . . . . . . . . . . . . . . . . . . . 18
7 Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 19

1 Operating Elements and Connections

1 Range switch
2 Button "0Ω CAL. SW" for bridging the jacks "
V.Ω.A" (10) for the 0 Ω calibration (with model MT-300 only):
"
while 0 Ω calibrating, keep this button pressed, by this the
short-circuiting of the test lead tips is not necessary which is
otherwise usual
3 Plug-in connections for testing transistors, with LEDs situated
above to indicate the transistor type (with model MT-300 only)
4 Jack "
5 Mirror scale to eliminate parallax errors while reading the
measuring value
6 Table with dB values which must be added to the reading value
during the dB measurement unless the lowest AC voltage
range has been selected
12
COM" for the black test lead (negative pole)
COM" (4) and