Master/Slave Mode; Operation With A Dmx Controller; Connection - IMG STAGELINE LED-162RGBW Manual De Instrucciones

Functional options
Button Function
Light off (blackout) / light on
ON / OFF
Automatic light show:
rotating light pattern and white running light
AUTO
Music-controlled light show:
rotating light pattern and white running light
MUSIC
Rotating light pattern / light pattern off;
A
can be combined with running light (button C)
When running light is on, selection of the run-
B
ning light program (press button repeatedly)
Running light on / off;
C
can be combined with light pattern (button A)
Pause / continue light effect
When button A has been pressed,
− +
selection of the light pattern
Speed
0 9
...
Without function
- --
Fig. 6 Functions of the remote control
Note: The display will change to
as one of the buttons is pressed .
Replacing the battery
1) Push the latch of the battery support to the
right (first arrow in figure 7) and pull out the
support (second arrow) .
1.
Fig. 7 Battery replacement
2) Remove the discharged battery and insert the
new battery (3 V button cell of type CR 2025)
in the support, positive pole facing upwards .
3) Push the support back into the remote
control .
Never put batteries in the household
waste . To protect the environment,
always take them to a special waste
disposal, e . g . collection container at
your retailer .

5.2 Master/slave mode

Multiple units LED-162RGBW can be operated
in sync . In this mode, a unit (master unit) will
control the other units (slave units) .
1) Connect the units in a chain . Please refer to
chapter 5 .3 .1, skipping step 1 .
(remote) as soon
2.
2) Set the slave units to the slave mode:
a) Press the button MENU repeatedly until
appears on the display .
b) Press the button ENTER to confirm and (at
the same time) save the setting .
3) At the master unit, select the operating mode
desired .

5.3 Operation with a DMX controller

For operation via a DMX light controller (e . g .
DMX-1440 or DMX-510USB from "img Stage
Line"), the LED-162RGBW is equipped with four
DMX control channels . However, it can also be
controlled via a single channel only if the func-
tions provided by this channel suffice (
or if less than four channels are available at the
light controller .
DMX stands for Digital Multiplex and means
digital control of multiple DMX units via a com-
mon control line .

5.3.1 Connection

For DMX signal transmission, special cables are
recommended (e . g . cables of the CDMXN series
from "img Stage Line") . For cable lengths ex-
ceeding 150 m and when controlling more than
32 units via a single DMX output, it is generally
recommended to insert a DMX level matching
amplifier (e . g . SR-103DMX) .
1) Connect the input DMX INPUT (14) to the
DMX output of the light controller or of a
different DMX-controlled unit .
2) Connect the output DMX OUTPUT (13) to
the DMX input of the second DMX-controlled
unit . Proceed in the same way to connect the
output of the second unit to the input of the
third unit etc . until all DMX-controlled units
have been connected in a chain .
3) To prevent interference in signal transmission,
in case of long cables or a multitude of units
connected in series, terminate the DMX out-
put of the last DMX unit in the chain with
a 120 Ω resistor (> 0 .3 W): Connect a cor-
responding terminating plug (e . g . DLT-123
from "img Stage Line") to the DMX output .
fig . 9)
☞
13