Master / Slave Mode - IMG STAGELINE RGBL-110DMX Manual De Instrucciones

5.1.2 Mode "Colour Individual Preset"
GB
Display : x
Various colour adjustments may be selected with
the buttons UP and DOWN (7). Then the segments
, and of the light bar show different colours.
x
0 off
1 red
2 green
3 blue
4 red
5 green
6 blue
7 green
blue
8
+ 50 % red
red
9
+ blue
5.1.3 Mode "Colour Preset"
Display : xx
Various colour adjustments may be selected with
the buttons UP and DOWN (7). The segments
and of the light bar always show the same
colours.
xx
0 off
1 red
2 green
3 blue
4 red + green
5 red + blue
6 green + blue
7 green + 50 % red
8 red + 50 % green
9 blue + 50 % green
10 green + 50 % blue
11 blue + 50 % red
12 red + 50 % blue
13 red + green + blue = white
All rights reserved by MONACOR
be reproduced in any form or by any means for any commercial use.
10
off off
green red
red green
red blue
blue red
blue green
green blue
red
green
+ 50 % green
green blue
+ 50 % blue + 50 % red
green red
+ blue + blue
‒
® INTERNATIONAL GmbH & Co. KG. No part of this instruction manual may

5.1.4 Master / slave mode

If several RGBL-110DMX units are connected with
each other to be controlled in sync, adjust the first
unit (master) to one of the modes described in
chapters 5.1.1 to 5.1.3. In these modes, the adjust-
ments are passed on as DMX control signals at the
DMX addresses 1 to 9 via the output jack (5) to the
other units (slaves).
Adjust the slave units to one of the two slave
modes with the button MODE (6):
= mode "slave, individual"
The brightness for red, green and blue is sepa-
rately controlled for the segments
(DMX addresses 1 to 9).
= mode "slave, all"
The brightness for red, green and blue is controlled
from the values of the DMX addresses 1 to 3 for the
three segments together.
Hint: As soon as a DMX control signal is present at the
input, the point of the first digit position lights up on the dis-
play (8).
5.2 Operation with DMX controller
The control by DMX light controller can either be
made via 4 or 12 control channels.
In the 12-channel mode (display:
,
ments , and
be controlled whereas in the 4-channel mode (dis-
play: ), all segments are controlled together.
After one of the two operating modes has been
selected with the button MODE (6), the DMX start
address has to be adjusted. For this purpose use
the buttons UP and DOWN (7). The display (8)
always shows the start address and the operating
mode alternately. After approx. 3 s, a change of the
start address will be effective automatically. In each
of the two modes the last start address adjusted will
be stored.
If e. g. the addresses 10 to 21 on the DMX con-
troller are provided to control the 12 channels of the
light bar, adjust the start address 10 on the RGBL-
110DMX.
To control the light bar via the LED-4MC, select
the 12-channel mode (display:
start address 1.
Hint: As soon as a DMX control signal is present at the
input, the point of the first digit position lights up on the dis-
play (8).
,
), the seg-
of the light bar can separately
) and adjust the
and