Using The Handset; Switching The Handset On And Off; Communicating - BRONDI PMR FX-100 TWIN Manual De Instrucciones

6. U
SING THE HANDSET

6.1 SWITCHING THE HANDSET ON AND OFF

When the radio is switched off, the display is switched off. In this
condition no operation can be performed.
IMPORTANT: we recommend that you switch off the handset
when the radio is not in use to prevent the batteries from being
completely discharged.
To switch the handset on, press the button and hold it down
until the handset issues a beep. At this point the display will show
the information related to operation as a 2-way radio. To switch
the handset off, press the button again and hold it down until
the handset issues a beep.

6.2 COMMUNICATING

With your BRONDI FX-100 you can communicate with another
BRONDI FX-100 handset or with any other 2-way radio that uses
the PMR 446 standard. You may communicate with an unlimited
number of PMR 446 handsets in conference.
ATTENTION: All the handsets must be tuned to the same channel
and the same CTCSS code to intercommunicate.
When using the handset, take care when communicating
confi dential information, as another PMR 446 handset near your
FX-100 which is tuned into the same channel may listen to your
conversation. Communication takes place alternately: if another
handset is transmitting, you must wait for the transmission to end
before speaking (pressing the PTT communication button on the
left side of the handset and holding it down) and vice versa.
Selecting the channel and the CTCSS (Continuous Tone Coded
Squelch System) code.
16