Communicating: Receiving And Transmitting - BRONDI PMR FX-100 TWIN Manual De Instrucciones

NOTE: If no button is pressed for 6 seconds during programming,
the handset will automatically return to stand-by and the
changes will be confi rmed.
6.3 COMMUNICATE: RECEIVING AND TRANSMITTING
To transmit or receive, all the handsets must be tuned into the
same channel and the same CTCSS code.
RECEIVING
When your handset is on and in stand-by, it is always ready to
receive communications which you will hear through the speaker.
At the end of every reception you will hear a "roger beep" meaning
that your contact is ready to receive your communication. When
receiving, the display will show the receiving symbol
ATTENTION: You cannot receive communications when the PTT
communication or CALL buttons are pressed, even if you are not
speaking.
CONTROLLING THE SPEAKER AND TUNE VOLUME
It is possible to set the speaker volume by pressing the + and -
buttons:
• press the + button to increase the volume;
• press the - button to decrease the volume.
Every time you select a volume level, the handset will issue a
beep and the display will show the level with a series of bars. The
level set will always be visible on the display.
TRANSMITTING
Transmission can only take place while the PTT communication
button is pressed, unless the VOX function is active.
1. Before starting communication check that channel is free, i.e.:
there is no receiving signal on the display
2. Press the PTT communication button and hold it down and the
transmission symbol
3. Speak into the microphone from a distance of 15 centimetres.
.
will appear on the display.
18
.