Call Function (Call); Personalising The Call Tune; (Deactivating The Automatic Squelch) - BRONDI PMR FX-100 TWIN Manual De Instrucciones

4. At the end of the transmission, release the PTT communication
button the handset will issue a "roger beep".
6.4 CALL FUNCTION
The CALL button allows you to call all the handsets synchronised on
your channel and CTCSS code and they will ring for two seconds;
others can call your handset in the same way.

6.5 PERSONALISING THE CALL TUNE

Your handset also allows you to personalise the tune with which
the other handsets will ring, using a simple program described
below.
In this way, those called will know that you are calling them.
1. Press the MENU button 4 times. The handset will enter the tune
programming mode and "CA" will appear on the display,
indicating the current setting which fl ashes (OF, 1, 2, 3, 4 or 5).
2. Press the + and – buttons to choose one of the 5 tunes; every
time you choose one, the display will show the corresponding
number and the handset will let you listen to them.
3. To exit this programming procedure, press and immediately
release the PTT communication button; the parameters set
up to now will be saved.
NOTE:
1. If, during programming, you choose "OF", you will set the
"silencer" function on your handset only. When you call the
other handsets, they will ring with the standard tune.
2. The previous programming does not alter the tune.
6.6 CHANNEL MONITORING

(deactivating the Automatic Squelch)

With this function you can listen to all the signals (even when very
weak) of the channel to which you are tunes, regardless of the
CTCSS code set, if any.
You can use this function to listen to communications at the limit of
the range of action.
19