Monitoring 2 Channels At Once - BRONDI PMR FX-100 TWIN Manual De Instrucciones

2. Press the + or – buttons to deactivate ("
On
activate (" " on the display) the tone.
3. To exit this programming procedure, press and immediately
release the PTT communication button; the parameters set up
to now will be saved.

6.13 MONITORING 2 CHANNELS AT ONCE

This function allows you to monitor two channels at the same time:
during this operation the handset constantly controls the primary
and secondary channels.
As soon as the handset receives a signal on one of the two stations,
it remains tuned to that station for the 5 seconds following the
termination of communication, after which it returns to monitoring
the two channels.
If you press the PTT communication button when receiving, the
handset will transmit on the same channel. If you press the PTT
communication button when no signal is detected, the handset
will transmit on the primary channel. When the function is active,
DCM
the letters will appear on the display.
NOTE: The primary channel is that currently set with the standard
choice of channels (see paragraph 6.2), the secondary
channel is that which is set using the activation procedure
of the function described below.
Activating the function:
To activate the function it is necessary to set the secondary channel
and the CTCSS code:
1. Press the MENU button 7 times. The "
display and the letters
2. Choose the channel required using the + or - buttons.
3. Then press the MENU button to change the CTCSS code and
0
the number " " in small print on the display will fl ash.
4. Choose the CTCSS code required using the + or - buttons.
5. Press the MENU button to confi rm and exit the mode.
Deactivating the function:
When the function is active,
of
" on the display) or
OF
" symbol will fl ash on the
DCM
will appear in small print.
23