Operating Elements And Connections; Safety Notes - IMG STAGELINE LED-4C Manual De Instrucciones

All operating elements and connections described
can be found on page 2.

1 Operating Elements and Connections

1 Buttons for colour selection in the hold mode [the
red LED above the button HOLD (2) must light up]
2 Button HOLD for switching on the hold mode
[colour selection via the buttons HOLD COLOURS
(1)]
3 Button CHASE for switching on the chase mode
[continuous colour change, colour selection via the
control CHASE/SPECTRUM MIX (5)]
4 Button SPECTRUM MIX for switching on the spec-
trum mode [colour selection via the control
CHASE/SPECTRUM MIX (5)]
5 Control CHASE/SPECTRUM MIX for colour
selection in the chase mode and spectrum mode
6 Control CHASE SPEED/FADE TIME:
in the chase mode for adjusting the colour
changing speed;
in the spectrum mode, when the control CHASE/
SPECTRUM MIX (5) is completely down in position
COLOUR FADE, for adjusting the fading speed
7 Control DIMMER for adjusting the brightness of the
spotlights; in the upper adjusting range the strob -
oscope function will be activated
8 Button SOUND for activating the music-controlled
colour change via the integrated microphone in the
chase mode
9 Button FULL ON: switches all LEDs of the con-
nected spotlights to maximum brightness as long
as the button is kept pressed
10 Button BLACKOUT: turns off the connected spot-
lights; if the button is pressed again, the unit is
switched back to the previous brightness
11 POWER switch
12 Jack DC INPUT for connecting the supplied power
supply unit
13 Jack DMX OUTPUT for connection to the DMX sig-
nal input of an LED spotlight

2 Safety Notes

The units (control panel and power supply unit) cor-
respond to all required directives of the EU and are
therefore marked with
WARNING The plug-in power supply unit is sup-
plied with hazardous mains voltage
(230 V~). Leave servicing to skilled per-
sonnel only. Inexpert handling may
cause an electric shock hazard.
It is essential to observe the following items:
G
The units are suitable for indoor use only. Protect
them against dripping water and splash water, high
air humidity, and heat (admissible ambient tempera-
ture range 0 – 40 °C).
G
Do not set the control panel into operation, and
immediately disconnect the power supply unit from
the mains socket if
1. there is visible damage to one of the units,
2. a defect might have occurred after a drop or simi-
lar accident,
3. malfunctions occur.
The units must in any case be repaired by skilled
personnel.
G
For cleaning only use a dry, soft cloth, never use
water or chemicals.
G
No guarantee claims for the units and no liability for
any resulting personal damage or material damage
will be accepted if the units are used for other pur-
poses than originally intended, if they are not cor-
rectly connected, operated, or not repaired in an
expert way.
If the units are to be put out of operation de-
finitively, take them to a local recycling plant
for a disposal which is not harmful to the envi-
ronment.
3 Applications
The control panel LED-4C serves for easy and con-
venient operation of LED spotlights which are con-
trolled via four DMX channels (
Channel 1: red
Channel 2: green
Channel 3: blue
Channel 4: dimmer, stroboscope
The following spotlights from the product range of "img
Stage Line" are e. g. recommended for this purpose:
PARL-30SPOT
PARL-30WASH
PARL-56PDX/...
PARL-64PDX/...
All spotlights connected to the LED-4C are controlled
synchronously. For different control of spotlights, sev -
eral control panels LED-4C must be used.
.
chapter 5.1):
GB
7