Overview Of The Components - Clatronic HSM R 3313 Instrucciones De Servicio

• This appliance is not intended for immersion in water for cleaning.
Follow the instructions provided in the chapter on "Cleaning and
Maintenance".
• Do not operate the hair and beard clippers with wet hands.
• Only cut dry hair with this unit.
• Only use this unit to cut head hair and beard.
• Do not press the clipper head too firmly onto the skin. Danger of
injury.
• Charge the unit in a cool and dry location.
• Only use the supplied power adapter.

Overview of the Components

1 Attachment comb (clipper head concealed)
2 Button (fold out clipper head)
3 Select button for cutting length 1 = 5 mm, 2 = 9 mm,
3 = 13 mm, 4 = 16 mm
(approx.; 3 mm without comp attachment)
4 Slide switch ON/OFF
5 Charge indicator
6 Charging station
Accessories
Hairdressing comb
Scissors
Cleaning brush
Power adaptor (charger)
Charging the Unit
• Turn the unit off.
• Connect the power adaptor connector with one of the
following jacks.
▪ The socket directly at the bottom end of the unit.
▪ Alternatively place the unit in the charging station. The
socket is at the rear.
• Plug the power adaptor into a wall outlet.
• The charge indicator turns on during charging.
NOTE:
The charge indicator does not indicate the state of charge of
the rechargeable battery.
• Charge the unit before first use for 14 hours.
• Later charges take 14 hours as well.
NOTE:
The unit cannot be operated with mains power.
CAUTION:
After 14 hours always disconnect from mains power supply.
NOTE: LIfETIME RECHARGEABLE BATTERY
You can extent the lifetime of the rechargeable battery by
following these steps:
• Only charge after the battery is nearly exhausted.
• Do not charge for more than 14 hours.
• Charge the unit at temperatures between 0° and + 40°C.
Clip and Cut Beard
• Select the cutting length with the attachment comb. Press
and slide the button (3).
• Slide the switch (4) towards the clipper head: Start with
the longest cutting stage and clip goatee, sideburns or full
beard step by step to the desired length.
Clip Hair
• Select the cutting length with the attachment comb. Press
and slide the button (3).
• Slide the switch (4) towards the clipper head: Start with the
longest cutting stage and clip your hair step by step to the
desired length.
Outlining and Shaving the Neck
NOTE:
The smallest setting of "3 mm" can be obtained by removing
the comb attachment.
• Remove the attachment comb (1) and slide the switch (4)
towards the clipper head.
• The clipper head allows precise outlining the shape of the
beard, even in difficult to reach places as well as a clean
shaving of the hair-line at the neck.
25