Please unfold page 3. Thus you will always be able to see
the operating elements and connections described.
1 Operating Elements and Connections
1 Trimming controls for sensitivity adjustment of the left and
the right channel
2 Selector switch for the display mode of the LEDs (3)
Position BAR = bargraph display
Example: If a level of -12 dB is measured
for a channel, all LEDs "-45 dB" to "-12 dB"
will light up.
Position DOT = dot display
Example: If a level of -12 dB is measured
for a channel, only the two LEDs "-12 dB"
will light up.
3 LED level display; indicating the level for the left channel
(upper row) and the right channel (lower row) in dB
4 Power switch
5 Low voltage jack for connecting the supplied plug-in trans-
former
6 Stereo input AUDIO IN for connecting the output of the sig-
nal source of which the level is to be indicated (e. g. mixer,
effect unit)
7 Stereo feed-through output AUDIO OUT for connecting the
input of a subsequent unit (e. g. amplifier, second mixer,
tape unit)
2 Safety Notes
The VU meter and the plug-in transformer correspond to the
directive for electromagnetic compatibility 89/336/EEC. The
plug-in transformer additionally corresponds to the low voltage
directive 73/23/EEC.
Attention! The plug-in transformer is supplied with hazard-
ous mains voltage (230 V~). Leave servicing to
authorized personnel only. Inexpert handling may
cause an electric shock hazard. Furthermore, any
guarantee claim will expire if the plug-in trans-
former or the VU meter have been opened.
Please observe the following items in any case:
The units are suitable for indoor use only. Protect them
against dripping water and splash water, high air humidity
and heat (admissible ambient temperature range 0 – 40 °C).
Even with the VU meter switched off, the plug-in transformer
connected to the mains has a low current consumption.
Do not operate the VU meter or immediately disconnect the
plug-in transformer from the mains socket:
GB
7